DIY: Recovering a Wingback Chair

When my husband and I moved into our house in October of 2009 we were thrilled that  his grandparents were going to give us their two wingback chairs, but the gray blue fabric that covered them just didn’t suit our style. After more than a year of dreaming about one day reupholstering the chairs, I took to ‘em with the help of my mom. Here’s how we did it.

It took approximately 5 days to complete this project. To do this project we needed:

  • Enough fabric for 2 chairs – we used about 12 yards
  • A flat head screwdriver and needle nosed pliers to remove staples
  • A sewing machine, seam ripper, and sewing scissors
  • I opted for a few yards of batting to cover the orange foam on the arms and chair back – it slightly showed through my fabric when under direct light
  • Staple gun
  • Hammer
  • Iron

We obviously started by searching for the right fabric. I had my heart set on a zebra print – and I found what I was looking for on FabricGuru.com.

The next step was to start taking apart the first chair. We decided to label each piece as we removed them from the chair. This way we could later use the pieces for patterns and we could easily identify which piece went where. Make sure you keep track of which pieces overlap others – in what order and where – and try to reuse tack strips from your chair if you can.

After cutting out your pieces, you will need to sew together your pieces like the wings, arms and seat cushions. I was lucky enough to have my mom do the sewing intensive pieces. There is no way I could have completed this project if I had to sew the arms on these chairs – at least if I wanted to keep my hair by the end of it.

Now is where that overlapping and order part comes in handy – you’ll need to start putting the pieces back on the chair like a puzzle. One by one staple and hammer your tack strips into place to put your pieces back on the chair.

Voila! You have a chair with fresh makeover. Sounds easy, huh? I will tell you I will probably never do this again. Without a lot of patience and wine I don’t think my mom and I would have finished… But I don’t regret it. I get so many wonderful compliments on my outrageous chairs.

This entry was posted in DIY. Bookmark the permalink.

3 Responses to DIY: Recovering a Wingback Chair

  1. Donna kerr says:

    I love these. I have just bought 2 wingback chairs and going to attempt recovering them in this fabric
    Wish me luck and we’ll done to you

  2. Lanie says:

    what type of fabric did you use? I too am looking for a zebra, but dont know weather i can you or should us fleece,linen,cotton,oilcloth, etc?

    • Carol Jordan says:

      Laine,

      I will have to double check what kind of fabric I used… But off the top of my head I can tell you it was a heavier canvas/duck-cloth/upholstery type of fabric.

      Carol :)

Leave a Reply

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>